You have 0 items in your cart.
Voltage Calibrator - Current Calibrator Signal source: DCV (Max. 30V), DCA (Max. 24 mA) Measurement: DCV (Max. 30V), DCA (Max. 100 mA) Features: Auto step (4 to 20mA), 20mA SINK, Sweep function Options: CA11E-2 Includes rubber boot, strap and accessory case
Signal source: DCV, DCA, OHM, RTD, TC (10 kinds), Frequency, PulseMeasurement: DCV, DCA, OHM, RTD, TC (10 kinds), Frequency, PulseFeatures: Highly accurate within 0.02% of the DC voltage range for source and measure.Source and measurement can be performed simultaneously.Vertical type with large-screen display.Loop power supply function (24 VDC at a load of up to 22 mA)It is possible to measure current in the mA range while supplying power.Sink function.Sweep functions that allow 3 types of continuous outputs.Options: 94010 AC adapter, 94015 NiMH Battery, 93027: Main Body case with strap
YPC4000 is a combination Calibrator / HART Communicator that reduces the time spent on field calibrations and the number of test instruments that have to be carried into the field. The YPC4000 Series delivers the versatility of a modular calibrator and the convenience of HART communications in one handheld unit. Users can view up to four measurements simultaneously on the high resolution LCD or compare HART PV and AO values to corresponding values measured. Available sensor modules include a variety of differential, gauge, vacuum and absolute pressure as well as voltage, current and temperature. A voltage and current meter is integral to the base unit. All HART field devices can be configured, polled, and trimmed using HART communications. Device Specific commands for more than 200 supported devices, including EJA/EJX pressure transmitters, YTA Temperature Transmitters, and Yewflo are available. *This product is handled by YOKOGAWA CORPORATION OF AMERICA in US. Please contact through your local Yokogawa's representative.
Compact & Light weight body with large back-lit LCD Current clamps in a range of sizes(small to large diameter) Support for large-capacity ATA flash memory (equipped with PC card slot) Data can be saved at from 1 second Wiring error check function 2 or 3-load system Simultaneous measurement of multiple use possible by external control terminal Parameters setting tool is included to set measurement conditions through PC
CW Viewer AP240E is data analyzing software for the CW240 Clamp-on Power meter. Making full use of the rich measuring functions of the CW240, this efficiently manages the large amounts of measurement data. Graph display Daily / weekly / monthly report display Data analysis Graph analysis display Report display
The CW240 power meter is a complete tool for enhancing energy efficiency, finding areas for improvement and assessing equipment lifecycles. The meter provides in-depth information on how an item of equipment, an area of a plant or a complete facility is operating that goes beyond simply measuring power usage. By using the supplied clamp-on components and probes, users can better determine maintenance, repair and replacement schedules for equipment such as transformers and motors. Information is provided with respect to load factors and demand factors, as well as current/voltage fluctuations at motor start-up.
The CW10 is more like a tester type rather than a recorder, which can measure single phase AC and DC Power, Voltage, Currents, Power Factor, Frequency, Harmonics. It will also contribute to workers maintenance of not only consuming equipment but equipment for renewable energy such as solar and wind power generation.
AC/DC current measurements with current ranges up to 300A 24mm in diameter of measurable conductor Light weight & compact design Mean value display Sleep function Approved for comformity to safety standards EN61010-1, EN61010-2-032 (CAT. III 300 V)